This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
ee:hydrophones:start [2019/10/17 19:07] Chris Nathman [Code] |
ee:hydrophones:start [2020/03/06 00:58] Chris Nathman |
||
---|---|---|---|
Line 134: | Line 134: | ||
reset:1 | reset:1 | ||
+ | |||
+ | frequency 35000 | ||
| | ||
The supported keys are as follows: | The supported keys are as follows: | ||
Line 140: | Line 142: | ||
| threshold | unsigned int | Sets the HydroZynq ping ADC threshold value. | | | threshold | unsigned int | Sets the HydroZynq ping ADC threshold value. | | ||
| debug | unsigned int | If data is 0, HydroZynq debug mode is disabled. Otherwise, debug mode is enabled. | | | debug | unsigned int | If data is 0, HydroZynq debug mode is disabled. Otherwise, debug mode is enabled. | | ||
- | | frequency | unsigned int | Specifies target pinger frequency. May be 25000, 30000, 35000, or 40000. Units are Hz. | | + | | frequency | unsigned int | Specifies target pinger frequency. May be 25000, 30000, 35000, or 40000. Units are Hz. **This must be set or the zynq will not look for pings.** | |
| post_ping_duration_us | unsigned int | The number of microseconds after ping threshold to truncate the signal to. //Default: 50 us//| | | post_ping_duration_us | unsigned int | The number of microseconds after ping threshold to truncate the signal to. //Default: 50 us//| | ||
| pre_ping_duration_us | unsigned int | The number of microseconds before ping threshold to truncate the signal to. //Default: 100 us//| | | pre_ping_duration_us | unsigned int | The number of microseconds before ping threshold to truncate the signal to. //Default: 100 us//| | ||
| filter | unsigned int | If data is 0, IIR filtering is disabled. Otherwise, filter is enabled. //Default: disabled.// | | | filter | unsigned int | If data is 0, IIR filtering is disabled. Otherwise, filter is enabled. //Default: disabled.// | | ||
+ | | print | N/A | Prints out all current zynq parameter values. | | ||
In debug mode, the HydroZynq records for 2.1 seconds, dumps all 2.1 seconds of data to the data stream port, and repeats. No correlations are performed and no result is sent. | In debug mode, the HydroZynq records for 2.1 seconds, dumps all 2.1 seconds of data to the data stream port, and repeats. No correlations are performed and no result is sent. |