User Tools
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
ee:hydrophones:start [2020/03/06 00:58] Chris Nathman |
ee:hydrophones:start [2020/03/06 01:20] (current) Chris Nathman [Communication] |
||
|---|---|---|---|
| Line 146: | Line 146: | ||
| | pre_ping_duration_us | unsigned int | The number of microseconds before ping threshold to truncate the signal to. //Default: 100 us//| | | pre_ping_duration_us | unsigned int | The number of microseconds before ping threshold to truncate the signal to. //Default: 100 us//| | ||
| | filter | unsigned int | If data is 0, IIR filtering is disabled. Otherwise, filter is enabled. //Default: disabled.// | | | filter | unsigned int | If data is 0, IIR filtering is disabled. Otherwise, filter is enabled. //Default: disabled.// | | ||
| + | | min_fft_samples | unsigned int | The minimum number of samples to be used in Fourier transforms. In situations where fewer than this number of samples are available (e.g. ping detected close to end of sample set such that only a small number of samples are left before the end of the data array), a fourier transform will not be performed and the zynq will have to resync with the ping. Performing Fourier transforms on small numbers of samples will likely cause inaccurate frequencies to be reported. //Default: 2048// | | ||
| | print | N/A | Prints out all current zynq parameter values. | | | print | N/A | Prints out all current zynq parameter values. | | ||
